Origami Frog

Eu faço um diferente deste mas não encontrei...

P.S. O meu é melhor!!!

Start with a square piece of paper!

1	Fold a perfect square of paper diagonally, to make a triangle. Fold again as shown.
2	Fold in half again and open up.
3	Holding down bottom layer, lift and fold top triangle layer and press flat into a square (A).
4	Flip over and repeat on back. You should end up with a square.
5	Position square with closed point at top. Fold and unfold top layer only on dotted lines as shown at left.
6	Holding down left side of diamond, take top right fold and place on top of center fold of the diamond, pressing flat.
7	Fold left side of triangle (B) on dotted line. Repeat step 6, but this time on the left side.
8	Model should look as shown. Flip over and repeat steps 5-8.
9	Model should have four layers of paper on each side with a horizontal edge visible. Fold and unfold on dotted lines (top layer only).
10	Lift horizontal edge of paper and fold on horizontal dotted line so that edges meet in the middle, pressing it flat as shown in (C).
11	Repeat steps 9-10 on three horizontal remaining layers. Model should have four layers of paper on each side with split ends on bottom.
12	Fold top layer only on dotted line as shown. Repeat on three remaining flaps.Model should look like (D).
13	Fold the two bottom points upwards and inwards as far as they will go.
14	Repeat with the two remaining points, but pull out to the sides to make the back legs.
15	Fold downwards and inwards on dotted lines to make the front and back leg joints.
16	Fold upwards and inwards on dotted lines to make tip of each leg. To inflate, blow into small hole at bottom as indicated by arrow.